Snap-On Panels have been designed for use in roofing,
mansard and fascia applications. Snap-On Panels are designed to be installed
over a waterproofed solid substrate and a minimum 3:12 roof pitch. Snap-On
Panels are to be factory roll-formed in continuous lengths. Maximum
panel length is 45 feet and minimum panel length is 4 feet.
These panels are ideal for specification on applications
where roof transitions are required. The simplicity of the pan design
combined with corrective leveling provides superior flatness and allows
for greater workability on site.
All flashing and trim will be fabricated by manufacturer or qualified
fabricator. Flashing shall be PAC-CLAD aluminum (.032-.063 gauge as
specified) or PAC-CLAD steel (22 ga. or 24 ga. as specified). A 20 year,
non-prorated warranty can be supplied covering finish performance.
The 1” high Snap-On Standing Seam Panel can now be curved to a
concave or convex radius, with a minimum radius of 9 ft. This panel
is ideal for barrel vaults and entrance ways. Curved panels must be
installed over a waterproofed solid substrate.
Snap-On Panels shall be installed over solid decking
(5/8” plywood, nailboard insulation or equal) with an underlayment
of 30# (min.) roofing felt applied horizontally from eave to ridge.
Panels shall be fastened using Petersen Non-Penetrating Clips, fastening
on 18” centers (max.). Minimum slope at 3:12 pitch. Consult a
local architect or engineer for requirements of local codes and conditions.
Conklin today for a FREE estimate regarding our exclusive
line of Pac Clad, Pac-Clad
Colors, Snap-Clad, Tite-Loc,
Tite-Loc Plus, Tite-Loc
HS, Snap-On Standing Seam,
High Snap-On Standing Seam,
Snap-On Batten, Redi-Roof
Standing Seam, Integral
Standing Seam, Integral Batten,
Panel, 1/2" &
7/8" Corrugated, R-41 &
R-36 Panels, Snow Guards and Pac